Can anyone tell me what the Deere code is for my 850C .. F446 comes up on the dash??
Deere codes for 850C
Case 420ct-3 hydraulic case drain
Seeing if anybody can take a picture of where the case drain ties into the hydraulic tank of a case 420ct-3. I am getting a factory case drain and just need to know if it ties into the tee at the tank that already exists. There is a cap on it so that is where I think they put them on at the factory. Just wanted to make sure first. The unit is non-high flow.
Case 420ct-3 hydraulic case drain
Komatsu D21P-7 wont trun left
Folks,
I have an older Komatsu D21P-7 doser. Runs strong and all controls work except a left turn when going forward. Turns strong to the right and both ways when going in reverse. Also need information on adjusting the brake(s). Got the machine on the cheap. Any advise welcome.
I have an older Komatsu D21P-7 doser. Runs strong and all controls work except a left turn when going forward. Turns strong to the right and both ways when going in reverse. Also need information on adjusting the brake(s). Got the machine on the cheap. Any advise welcome.
Komatsu D21P-7 wont trun left
Fancy Hard-Face
I was in Kake Alaska a few weeks back doing recon for a project. This dozer was parked along the road. I got a big kick out of the hard-face job with the state and national flags. What do you think?
Fancy Hard-Face
Grove RT-60S crane outriggers not holding well
I just noticed that some outriggers on my Grove RT-60S are not holding well and slowly come down.
Here's what I know:
- They come down maybe 1/4"-1/2" per minute
- There is NO oil coming out of them, no pool of oil under them
My understanding is that the piston seal leaks, which equalizes the pressure between top and bottom oil, at which point it engages the counterbalance valve and as a result the outrigger comes down.
Would anyone comment on my diagnosis.
We can pull and rebuilt hydraulic cylinders in-house if necessary.
Here's what I know:
- They come down maybe 1/4"-1/2" per minute
- There is NO oil coming out of them, no pool of oil under them
My understanding is that the piston seal leaks, which equalizes the pressure between top and bottom oil, at which point it engages the counterbalance valve and as a result the outrigger comes down.
Would anyone comment on my diagnosis.
We can pull and rebuilt hydraulic cylinders in-house if necessary.
Grove RT-60S crane outriggers not holding well
Generic (unknown) OTT replacement dogbones ?
I picked up a set of unknown Over the tire tracks, and the dogbone links are worn out.
They measure 4" center to center.
IIRC I found a low cost supplier (and can't re-find them).
Any links ?
They measure 4" center to center.
IIRC I found a low cost supplier (and can't re-find them).
Any links ?
Generic (unknown) OTT replacement dogbones ?
Inscription à :
Articles (Atom)