Anything supposed to be in here?

Is they're supposed to be anything inside of the air cleaner pre-cleaner? any kind of filter element or is it just open like this?

It's off a 67 case 580ck 188 diesel

Anything supposed to be in here?

Hitachi EX60 URG need electrical diagram

No prior electrical problems but now the starter (key) switch produces nothing. Turning the ignition on lights the dash lights and the fan and other accessories work.

I can engage the starter by jumping the high-amperage solenoid located just inside the engine door and putting +24v to the white-red wire (running to the starter solenoid) on the same unit. So the starter and it's interconnecting wiring is all functional.

If I could find a wiring diagram showing the basic pieces and...

Hitachi EX60 URG need electrical diagram

Hitachi EX60 URG need electrical diagram

Allis Chalmers HW250

Found This dozer in the bush. Apparently this dozer was made in italy and is considered very rare.Does anyone know where to get parts for this dozer?
(lookin at just a farm tractor/restoration build).
The decals say HD11 but is incorrect.
Apparently it is an HW250

Allis Chalmers HW250

Trojan Hydraulic Pump

I Need advice from a hydraulics guru to assist in finding parts for my 1989 Trojan Loader. The 1500Z and 1700Z loaders use the same pump. According to Weser Pumpen, the current pump is WP340-3 and only available in German at $500 more than I paid for the loader.

The pump flange (shaft housing to transmission) had a seized bearing and damage the housing. The previous owner must have had problems as well because the shaft that connects the trans to the pump is about 1/2" short and the...

Trojan Hydraulic Pump

Trojan Hydraulic Pump

Case 40 XT Newb with lots of Questions

I have had no luck searching here.I have a 2003 40xt with some issues.I have been online looking for a shop manual all day with no luck.I think my Hyd fluid is leaking into my chains on the left side.Can the drive motor do this?All I know is I have fluid coming out of the rubber plug in the floor pan>Anybody heard of this before?Any help would be great!

Case 40 XT Newb with lots of Questions

Junkayrd's work thread.....maybe haha

While I don't do stuff near as cool as most of you I figured I'd start showing what I do on a regular basis. I'd like to name my favorites on here, but being a father of five I've learned to avoid hurt feelings haha. I manage equipment for a small excavating company. We run a D11N, D7R, D5G, D65, Steiger 485 HD with two 19 yard pans, two 210 Linkbelts, 110 SD roller, champion grader, 627B and a couple water trucks. I do all the service work and 99% of the repairs. Just did steering...

Junkayrd's work thread.....maybe haha

Junkayrd's work thread.....maybe haha

Track master pin question

I need to break the right track on my Case 1150 (straight 1150 no letter) and when I looked for the master pin they all look the same. My D7 has a center punch on the master pin but all of these seem to have a center punch? Any help determining which pin to remove? Thanks

Track master pin question