Fiat Allis 262B's

slow going gradall telehandler

I have a 2001 Gradall 534c6 telehandler with a pile of hours but does the job around the farm so really not interested in upgrading for 15hrs of use each season. I have a couple problems currently. 1st problem is the speed which is about 3 mph tops going forward, reverse just a bit better but not much. Yes, I have the left side inching peddle all the way back. I have the traction control peddle back also. 4x4 switch is also off on dash. Hydraulic fluid is 2/3 up on site glass so is fine....

slow going gradall telehandler

slow going gradall telehandler

Snorkel tba50r drive issues

I picked up a classic/antique 1986 tba50r which worked pretty well for about a month but lately it has exhibited 2 problems. The more minor issue is that voltage is slightly low on the starter solenoid trigger wire from the basket. 11.5 volts as opposed to 13ish volts when using ground controls. The second issue is that sometimes it will refuse to go in fwd or reverse. Every other function works fine and it might be coincidence but a couple times when I was holding the drive joystick and...

Snorkel tba50r drive issues

Snorkel tba50r drive issues

Installing a Perkins Engine Into a RD90 Read Screen.

What do I need(auxiliary gear pump, drive gear shaft)to install a Perkins C4.4 1204E-E44TA engine into a Read Screen RD-90 serial# 568388? The Perkins engine is a Tier 4 Interim engine. The engine type is 3658/2200. This means that it is 94BHP@2200RPM. Also, are the necessary components Perkins parts?

Installing a Perkins Engine Into a RD90 Read Screen.

Looking for new steering cylinder for case 680e or make a 580 one fit loo

I need new steering cylinders for my case 680e backhoe. I’ve honed and repacked all cylinders on the backhoe and drained and flushed all hyd fluid .

The steering cylinders are the only thing stopping me from running it any one know where I can buy some from ?

Can some one get my all the sizes from case580 steering cylinders to see if I can make them fit?

Looking for new steering cylinder for case 680e or make a 580 one fit loo

3406b bad motor- how to clean air to air and intake piping

So I bought a pete (1992) with a motor knock in it. 3406 b, air to air, spacer plate motor, no jakes, supposed to be 425 but no tag on engine.

Dropped pan and one piston has been replaced, and sleeve. The other pistons are looose in the sleeves. Practically fall. I think the knock was actually a piston rocking in a sleeve after it warmed up.

We pulled intake piping, and its full of fine dust/rust/ maybe feed mill dust or clay from a end dump trailer. I'm thinking they ruined a air...

3406b bad motor- how to clean air to air and intake piping

3406b bad motor- how to clean air to air and intake piping

2016 MUSTANG 2700V NXT2

New unit has been in a couple shows, fully loaded Cab, A/C, Heat, Stereo, Pilot control, run flat tires, Yanmar 70.7 Hp, 2700 Lb Rated Operating Capacity, Self Leveling, Verticle Lift, 130.3" Dump Height.

www.equipsellsit.com/category/1580/skid-steers

2016 MUSTANG 2700V NXT2