i have a question about something phil posted in this thread http://ift.tt/1Eu3oWT
phil stated in post 8 The third test is the converter pressure check. Likely your machine is later than ser.#8314666, and has a 'converter charged in neutral circuit'. Remove the pipe plug located beside the converter temperature sending unit. With transmission in neutral, clutch engaged, engine warm, at 1500rpm, converter pressure should be 30-40 psi. Phil
my serial # is5228539 which is quite lower so does my backhoe not have the ability to have this test done or is there a different way of doing it
phil stated in post 8 The third test is the converter pressure check. Likely your machine is later than ser.#8314666, and has a 'converter charged in neutral circuit'. Remove the pipe plug located beside the converter temperature sending unit. With transmission in neutral, clutch engaged, engine warm, at 1500rpm, converter pressure should be 30-40 psi. Phil
my serial # is5228539 which is quite lower so does my backhoe not have the ability to have this test done or is there a different way of doing it
508b converter pressure check
0 commentaires:
Enregistrer un commentaire