Hello,
I am working with a 2015 745C, and am needing to monitor my dump cycles. Basically, we have a GPS tracking device on all of our equipment, and we are wanting to send an alarm (or signal) every time a load is dumped. Normally, the gps hardware will tie into a line that is normally 0v. When the dump cycle is started, that line will go up to 12v or 24v. That increase in voltage (or that line going high) is the "trigger" we are looking for.
I have the Caterpillar SIS software, and am looking at the schematics. (Attached to this post). Should I be looking at the "Hoist Raise Solenoid" or should I be looking at the signal wire under the joystick?
Thanks for you input!
I am working with a 2015 745C, and am needing to monitor my dump cycles. Basically, we have a GPS tracking device on all of our equipment, and we are wanting to send an alarm (or signal) every time a load is dumped. Normally, the gps hardware will tie into a line that is normally 0v. When the dump cycle is started, that line will go up to 12v or 24v. That increase in voltage (or that line going high) is the "trigger" we are looking for.
I have the Caterpillar SIS software, and am looking at the schematics. (Attached to this post). Should I be looking at the "Hoist Raise Solenoid" or should I be looking at the signal wire under the joystick?
Thanks for you input!
745C Electronics -- Monitor dump cycle
0 commentaires:
Enregistrer un commentaire