Good Morning,
I have bench tested the solenoid and when applying 12v it moves the plunger. I have checked the wiring and have 12v at the solenoid, floor micro switch(relay) and bucket control handle. I have looked at the schematic I have from some books I purchased for it (3) case manuals but the schematic shows connector which stated are not used on the "E" model and leaves me to follow nothing. The micro switch is powered constantly leaving me to believe it is powered to NC and when switches are grounded it releases. I am at a loss as to where to look now, any and all help is greatly appreciated. One note to add, the unit did work at one time, I just don't use it all the time so last time I wanted to shift, it didn't function.
Thanks All in advance,
Bob
I have bench tested the solenoid and when applying 12v it moves the plunger. I have checked the wiring and have 12v at the solenoid, floor micro switch(relay) and bucket control handle. I have looked at the schematic I have from some books I purchased for it (3) case manuals but the schematic shows connector which stated are not used on the "E" model and leaves me to follow nothing. The micro switch is powered constantly leaving me to believe it is powered to NC and when switches are grounded it releases. I am at a loss as to where to look now, any and all help is greatly appreciated. One note to add, the unit did work at one time, I just don't use it all the time so last time I wanted to shift, it didn't function.
Thanks All in advance,
Bob
1989 Case 408E ll Shuttle Cut Off Solenoid
0 commentaires:
Enregistrer un commentaire