I have a CAT 304C CR with a dead hour meter, Hot and ground are good per meter but no signal from ECM. Any ideas on how to fix or where to start to trace wires?
Cat 304C CR hour meter problem
Inscription à :
Publier les commentaires (Atom)
Popular Posts
-
I have a 2017 JCB 526-60, engine runs good, steering works, cant switch steering modes , boom wont go up or down, wont move forward or rever... -
Hello, I have five stored DTCs on my 2013 JD 332E. I tried searching through my repair manual and operators manual for codes, as well as the...
-
In Dec 2012 I bought a new, custom ordered from the factory, L220 SSL. I chose this brand/model as the "best" for my purposes in t...
-
Attached Images Off topic... What happens when reparing a JCB 3cx someone offers a bottle of wine
-
So I have recently started back to work for a utilities contractor after some years off as a service tech. 2 things have came into play sinc...
-
Hi All, I am new to the forum, and new to this line of work. I am looking for opinions on two items: Cat vs Bobcat? (they and Case are the o...
-
DTB01483 1665 hours Checking and cleaning grounds. Found harness to air sensor near air cleaner laying on turbo, repaired melted wiring. ...
-
Hi, not sure if this is an appropriate question but i have a 2001 212S that needs a new starter. Checking through JCB it cost just over $500...
0 commentaires:
Enregistrer un commentaire