Hello!
We have a genie s-125 and when you raise the boom it stops at 10 degrees and display fault code p22 safety switch fault and p22r safety switch fault.
I replaced the platform tilt sensor but it made no difference.
Genie told me it might be the platform ecu but im not sure how to check that.
So , does any one here have a clue how to proceed from here?
Best regards //Johan
We have a genie s-125 and when you raise the boom it stops at 10 degrees and display fault code p22 safety switch fault and p22r safety switch fault.
I replaced the platform tilt sensor but it made no difference.
Genie told me it might be the platform ecu but im not sure how to check that.
So , does any one here have a clue how to proceed from here?
Best regards //Johan
Genie s-125
0 commentaires:
Enregistrer un commentaire