Has a code 73 on display. Cleaned connections at plug on valve body and trans harness on back of cab. Any ideas, code list, and or wiring diagram- trouble shooting flow chart?
JCB 436 ZX won't move
Inscription à :
Publier les commentaires (Atom)
Popular Posts
-
I have a 2017 JCB 526-60, engine runs good, steering works, cant switch steering modes , boom wont go up or down, wont move forward or rever... -
Hello, I have five stored DTCs on my 2013 JD 332E. I tried searching through my repair manual and operators manual for codes, as well as the...
-
In Dec 2012 I bought a new, custom ordered from the factory, L220 SSL. I chose this brand/model as the "best" for my purposes in t...
-
Attached Images Off topic... What happens when reparing a JCB 3cx someone offers a bottle of wine
-
So I have recently started back to work for a utilities contractor after some years off as a service tech. 2 things have came into play sinc...
-
Hi All, I am new to the forum, and new to this line of work. I am looking for opinions on two items: Cat vs Bobcat? (they and Case are the o...
-
DTB01483 1665 hours Checking and cleaning grounds. Found harness to air sensor near air cleaner laying on turbo, repaired melted wiring. ...
-
Hi, not sure if this is an appropriate question but i have a 2001 212S that needs a new starter. Checking through JCB it cost just over $500...
0 commentaires:
Enregistrer un commentaire