To start off with I just bought this machine. I started it and unloaded off the truck just fine. It needed new batteries so did so a couple days later the machine started and ran well. I walked into our shop to grab grease gun then I heard the machine die. I found I had a bad connection on a battery cable as it melted the soder off the end of one cable. From this ponit the machine would not start. It got to where the stater would not roll it over. I removed the starter and sure enough the abindix was stuck out so I knew I had a problem there so I had it rebuilt. After i put it back on, the starter will not roll the engine over. At this point I think it is a crank bearing. I have a tool to put in the bell housing to ratchet the engine over. The engine rolls over really well one direction but not the other. As I am checking voltage it rolls over great but I let off the key switch out of habit and it has yet to try to roll over at all but the starter. Is there a such thing as it being hydro locked? Or any other suggestions?
Deere 892e lc will not start.
0 commentaires:
Enregistrer un commentaire