CASE 1150 Equaliser Beam (R55857) repair

Hi all,

Now I am not 100% sure but someone bodged the self aligning bearings in the end of the equaliser on my machine.

There is a solid steel bush in there with a taper on each side to allow it to roll with the track movement; Not good especially since I want to fit the new bearings, pin and end bracket out on the track frame (which we have in stock).

My question is could I cut the ends off the equaliser and machine out the mess then weld it back on; Is the steel of that part...

CASE 1150 Equaliser Beam (R55857) repair

CASE 1150 Equaliser Beam (R55857) repair