Hey hef I got a good one here d8h 46a 16xxxish just put new bearings seals pinon and ring gear set preload backlash on bevel gear shaft pressed hubs on with new cat tooling tried to do a nice job. Back it out of shop clutches won't release used cat assembly lube to hold the white piston seals in place. At idle 265psi going down tubes to clutch packs. Last two I did with the grease and they took alil bit but did release. Put 7000 psi on ram witch came out to 37 tons on 55 ton press. And about...
Steering clutch seal failure... New seals
Steering clutch seal failure... New seals
0 commentaires:
Enregistrer un commentaire