I'm putting a new head gasket in and I don't have the amount to torque the head bolts -when I took off the head the bolt were VERY tight-Thanks -Tom
JCB 1400 head bolt torque
Inscription à :
Publier les commentaires (Atom)
Popular Posts
-
I have a 2017 JCB 526-60, engine runs good, steering works, cant switch steering modes , boom wont go up or down, wont move forward or rever... -
DTB01483 1665 hours Checking and cleaning grounds. Found harness to air sensor near air cleaner laying on turbo, repaired melted wiring. ...
-
I have a problem with the air conditioner in my machine where it comes up with a L01 fault code and switches the air conditioner off, I have...
-
I was hope someone can help me with finding a manual for this. The hyd fluid is getting over into the steering system and whenbi caller cate...
-
Hi would anybody have any info on the Cummins390 engine in my case 580k. Where would i get some info in it, think mine is locked up , would...
-
I know certain types of cinders are used to make concrete block. Anyone know if cinders are used anywhere as a road base instead of limerock...
-
This wasn't what I thought it was, can anyone tell me anything about it? http://ift.tt/1laMWC5 Sent from my SCH-I545 using Tapatalk
-
Hi guys I got a question for you guys, I operate a small but very busy repair shop mostly ag equipment but do a fair bit of heavy equipment...
0 commentaires:
Enregistrer un commentaire