Any tips on how to handle a very leaky gland seal on the 6" diameter dipper cylinder. Can it be done on the machine? I have to replace the extendahoe hoses too and thought if I slid the extendahoe section off I could tilt the dipper cylinder up enough to do the seals while the barrel of the cylinder is still on the hoe? Sound reasonable? I just did the clam cylinder on the loader, it was a 3" and I had a hard time with the gland nut so any tips on getting the gland nut off the 6" cylinder? I used a very large pipe wrench for the 3" but I do not think it will work for the 6". Don't want to spend $100 plus for a gland wrench.
Thanks in advance for any help with this.
Thanks in advance for any help with this.
case 580k dipper cykinder
0 commentaires:
Enregistrer un commentaire