A question, what tricks and gadget's are you using to keep gaskets in place during assembly?
A Snap On dealer had a neat little clip devise that you pinched it closed and inserted it into the bolt hole past the gasket, when you release it, two tabs held the gasket in place, after the bolts were started in other holes, you pinched it closed and pulled it out, and inserted the bolt.
Anyone else use them? Is there anything like it out there?
Thanks,
Bob
A Snap On dealer had a neat little clip devise that you pinched it closed and inserted it into the bolt hole past the gasket, when you release it, two tabs held the gasket in place, after the bolts were started in other holes, you pinched it closed and pulled it out, and inserted the bolt.
Anyone else use them? Is there anything like it out there?
Thanks,
Bob
Keeping gaskets in place during assembly
0 commentaires:
Enregistrer un commentaire