It seems the pintle arm seals are leaking more heavily than I originally imagined(maybe even while the machine just sits).
I've only run the 863F about a dozen times for a total of about 50min. and now the dipstick comes out dry.
My thought was that maybe the BICS valve started locking more frequently as the fluid level got lower until it now just locks immediately when I try tilt.
Lift still works but maybe because the tilt actuator is above the lift it gets less fluid?
Also just noticed that the lower actuator is very loose as if the mounting bolt is almost completely out.
Is this common?
I've only run the 863F about a dozen times for a total of about 50min. and now the dipstick comes out dry.
My thought was that maybe the BICS valve started locking more frequently as the fluid level got lower until it now just locks immediately when I try tilt.
Lift still works but maybe because the tilt actuator is above the lift it gets less fluid?
Also just noticed that the lower actuator is very loose as if the mounting bolt is almost completely out.
Is this common?
could low hydraulic fluid cause valve lock?
0 commentaires:
Enregistrer un commentaire