The lift won't start unless the boom is operating and have to keep moving the control or it will die. Is there a safety switch or solenoid that would cause that issue.
2007 genie gth 644
Inscription à :
Publier les commentaires (Atom)
Popular Posts
-
Hello, I have five stored DTCs on my 2013 JD 332E. I tried searching through my repair manual and operators manual for codes, as well as the... -
I have a 2017 JCB 526-60, engine runs good, steering works, cant switch steering modes , boom wont go up or down, wont move forward or rever...
-
In Dec 2012 I bought a new, custom ordered from the factory, L220 SSL. I chose this brand/model as the "best" for my purposes in t...
-
Attached Images Off topic... What happens when reparing a JCB 3cx someone offers a bottle of wine
-
Hi, not sure if this is an appropriate question but i have a 2001 212S that needs a new starter. Checking through JCB it cost just over $500...
-
I have a problem with the air conditioner in my machine where it comes up with a L01 fault code and switches the air conditioner off, I have...
-
DTB01483 1665 hours Checking and cleaning grounds. Found harness to air sensor near air cleaner laying on turbo, repaired melted wiring. ...
-
When I fire up the backhoe, the park brake will intermittently release when using the unlock switch. Every now and then it will release on t...
0 commentaires:
Enregistrer un commentaire