Using the 955L and oil starts blowing down next to the belly pan. Get the pan off and appears what happed prior to this issue, was the machine was run without the pan and it hit something that cracked the transmission case, and the two lift lines. The up line was replaced but not the down. The stuff on the pan is silicone and has some soft spots. My pan is to drain, scrape the stuff off and see if something like JB weld would be a better fix.
What caused the leak was the seal blew out. The down line used a seal which has metal around the outside and is also old. The down line is bent and resting against the trans case and is starting to wear through. Plan to replace it and CAT wants $1066 for it. There are some used ones out there, going to see what they show up as.
The pic didn't come out that great but where it leaked shows some slight surface rust (sort of) in just one area.
The other thing I want to do is replace the bearing on the lifting arm which hold the bucket. There is very little of it left, pretty thin. Any advice on how to get the one out?
What caused the leak was the seal blew out. The down line used a seal which has metal around the outside and is also old. The down line is bent and resting against the trans case and is starting to wear through. Plan to replace it and CAT wants $1066 for it. There are some used ones out there, going to see what they show up as.
The pic didn't come out that great but where it leaked shows some slight surface rust (sort of) in just one area.
The other thing I want to do is replace the bearing on the lifting arm which hold the bucket. There is very little of it left, pretty thin. Any advice on how to get the one out?
Cracked tranny and bearing replacement
0 commentaires:
Enregistrer un commentaire