I have a case 590sl with a hydraulic amulet thumb that is sharing the center pin. Trying to change buckets that mean need to drive the center pin out.
Just can't seem to get the tension off the pin to drive it out. Pin can be hammered until just about flush on the hammering side than seems to bind. Tried drift pin to drive out but seems way to tight . I know the pin on a bucket alone should be hand loose. Can't get to that point. Any idea's or tricks? Also have to somehow chain the thumb to the dipper or else it might swing free and pull the hydraulic line off. Bucket was put down flush on the bottom andpin went fine until flush with thumb ears then seems to bind?
Just can't seem to get the tension off the pin to drive it out. Pin can be hammered until just about flush on the hammering side than seems to bind. Tried drift pin to drive out but seems way to tight . I know the pin on a bucket alone should be hand loose. Can't get to that point. Any idea's or tricks? Also have to somehow chain the thumb to the dipper or else it might swing free and pull the hydraulic line off. Bucket was put down flush on the bottom andpin went fine until flush with thumb ears then seems to bind?
changing bucket that has amulet thumb attachment
0 commentaires:
Enregistrer un commentaire