Hello everyone and thank you reading my post,
I am new to the forum and I am having issues with my bobcat 331 mini excavator. I replaced a hydraulic control solenoid under the floor panel early this week and when i went to test the solenoid before buttoning everything up i blew a fuse because i had some bare wires :(. i found a fuse box under the right hand controls and found that the ignition fuse was blown, no others, after replacing the fuse i then had power and the machine would crank but not start. I notice the oil pressure light on the cluster was no longer lighting up when key was turned on, i got the machine running by holding the fuel solenoid open. From there i jumped the pull and hold terminal and was able to energize the solenoid, i have 10ohms on the hold coil and straight continuity on the pull(sounds odd but like i said it worked when jumped) i have not had any luck with wiring diagrams however i know to the relay i have good 12v and ground but i dont see any controled power going to the relay so my guess is either there is another relay or fuse i have yet to find or i have a ecm or wire problem.
Please for the love of god help me!!! haha thanks for reading
I am new to the forum and I am having issues with my bobcat 331 mini excavator. I replaced a hydraulic control solenoid under the floor panel early this week and when i went to test the solenoid before buttoning everything up i blew a fuse because i had some bare wires :(. i found a fuse box under the right hand controls and found that the ignition fuse was blown, no others, after replacing the fuse i then had power and the machine would crank but not start. I notice the oil pressure light on the cluster was no longer lighting up when key was turned on, i got the machine running by holding the fuel solenoid open. From there i jumped the pull and hold terminal and was able to energize the solenoid, i have 10ohms on the hold coil and straight continuity on the pull(sounds odd but like i said it worked when jumped) i have not had any luck with wiring diagrams however i know to the relay i have good 12v and ground but i dont see any controled power going to the relay so my guess is either there is another relay or fuse i have yet to find or i have a ecm or wire problem.
Please for the love of god help me!!! haha thanks for reading
BOBCAT 331 Wont start/Fuel shut off solenoid issue
0 commentaires:
Enregistrer un commentaire