Thought I would run it past some of the sharp fellas that look on this forum. I'll start from the beginning,machine is a 2006 240lx with a Waratah 622b processing head. When machine gets warm that is when it starts acting up. after about an hour of running the stick will start to slow and pull the engine down,especially when pulling in towards you. After pulling the stick in it will continue to drift in slowly until pushing the the stick out again.The mechanic pulled the load hold check valve for the circuit and rebuilt it and swapped it with the load hold valve from the boom circuit, figuring that the problem would move to the boom if the check valve was faulty. Didn't solve or move the problem. Checked the pilot pressure and it was low. Manual calls for 585psi and machine had 280psi. I have ordered a new pilot pump hoping that it will solve the problem. If that doesn't fix it I don't know where to look next. Any ideas appreciated. Thanks in advance.
Ps. I think this machine is similar to the case cx240 and the sumitomo dash 3 series. But I'm not 100% sure.
Ps. I think this machine is similar to the case cx240 and the sumitomo dash 3 series. But I'm not 100% sure.
Link belt 240lx hydraulic head scratcher
0 commentaires:
Enregistrer un commentaire