I'm working on an EX400-3H that another person put new pumps in. There's been problems ever since and when I checked the voltage on the angle sensors there's a 1 1/2 volt difference between the two. My problem is that my DR EX died and that's the only way I've known of to adjust angle sensors on EX400s and bigger. Does anyone know of a different way? I tried to adjust them close by using the break out harness and volt meter but can't get them close. One is at 3.38 volts, the other is at 1.50 volts and that is max voltage. I took the low one out to make sure it was installed correctly and it is. If I bring the high one down to 1.5 volts the machine will not operate. Any thoughts?
Inscription à :
Publier les commentaires (Atom)
0 commentaires:
Enregistrer un commentaire