Not sure if these details pertain to my error code however i'll give all info and you can determine. While working my skidsteer i had it on a sharp decline, fuel was low enough that it ran out of fuel. topped it up and fortunately it started with little difficulty. After 10mins of problem free usage i shut it down and went in for supper, upon returning i turned the key on and the #17 general warning light came on. it started fine and worked good for about 15seconds then it lossed power and seemed as if it were starving for fuel. I shut it off started it again but it slowly died out and wouldnt restart. I held the light button in until it displayed the 12-23 error code. After researching the manual it says the problem is 12-Front auxillary PWM Switch(Proportional Control) 23-not calibrated. The manual does not direct me to this area, any suggestions on what and where to go from here.
864 bobcat error code 12-23
0 commentaires:
Enregistrer un commentaire