New here. First post a couple of days ago. When I check the hydraulic level in the tank I notice just a slight amount of milky looking fluid on the very end of the dipstick. This is when the machine and oil are cold. Today I unscrewed the filter to change it and immediately milky fluid ran over the filter as I unscrewed it. It was obviously not the same as the clear fluid but wasn't so bad that I couldn't read the writing on the filter as it ran over it. I suspect this isn't a good thing or it may be "normal" at the filter. I need some advice. How concerned should I be and what steps should I take? Thanks.
Case 580SE Milky Hydraulic Fluid
0 commentaires:
Enregistrer un commentaire