In the print below, snap ring # 13 is supposed to be .090"-.093" thick.
http://ift.tt/1KDEuEI
Problem is, the lower groove in my housing is much narrower.http://ift.tt/1Mr1PRr
The snap rings I removed were .092, .084 and .052. All show where they have been firmly in place in a groove and I think I remember taking all of them out of a groove.
At the time I wasn't worried about where they came from because I figured my manual would tell me where they went but this time, that line of thought has bit me solidly on the a$$.
There's no way a .093" snap ring will fit where it's shown to be placed, the groove is far too narrow, but the .052" thick one I removed from somewhere, will fit at position #13.
Anyone have any idea what is going on?
http://ift.tt/1KDEuEI
Problem is, the lower groove in my housing is much narrower.http://ift.tt/1Mr1PRr
The snap rings I removed were .092, .084 and .052. All show where they have been firmly in place in a groove and I think I remember taking all of them out of a groove.
At the time I wasn't worried about where they came from because I figured my manual would tell me where they went but this time, that line of thought has bit me solidly on the a$$.
There's no way a .093" snap ring will fit where it's shown to be placed, the groove is far too narrow, but the .052" thick one I removed from somewhere, will fit at position #13.
Anyone have any idea what is going on?
Borg Warner Shuttle Forward Clutch Assembly Question
0 commentaires:
Enregistrer un commentaire