The two speed travel is not working. Pushing the button on the blade lever causes the green light to come on indicating switch to high range.
However the machine stays in low range. I checked where the switch mounted on the hydraulic valve plugs into the wiring harness, it registers 12 V.
Is there any way to tell for sure that the switch is bad? Can this valve shaft be moved manually? Any help would be very much appreciated.
However the machine stays in low range. I checked where the switch mounted on the hydraulic valve plugs into the wiring harness, it registers 12 V.
Is there any way to tell for sure that the switch is bad? Can this valve shaft be moved manually? Any help would be very much appreciated.
0 commentaires:
Enregistrer un commentaire